How do I hand the designer sheet?
It’s a simple DIY task. The designer sheet Can be applied in a variety of ways depending on the surface and personal preference. You can use thin plywood or wood panels, placing them on the entire back surface or only top and bottom. Hang it from the wood or use strong double-sided adhesive and place directly on the wall.
You can also use nails or staples ( depending on the designated surface) but in our opinion, it is less recommended.
If needed, use a Stanley knife and ruler to adjust the size and fit. Apply on a completely clean and dry surface. Do not tape the entire frame to allow your surface a little breathing room. We do not recommend installing on walls subjected to moisture infiltration such as bathrooms to avoid mold accumulation. Do not place next to a fireplace
How do I apply deco stickers?
- Make sure the desired surface is clean, dry and preferably smooth.
- Use a dry cloth or a squeegee to gently rub the sticker on to the surface smoothing it out and pushing out air bubbles as you gradually continue to apply the sticker in its entirety.
- If necessary, the stickers can be removed from most hard surfaces with no damage or residue, other than when applied directly on painted wall, in which case some peeling and slight damage may occur.
- In case applied inaccurately, the sticker can be removed and re-applied if done instantly.
- Do not place directly on and/or next to a fire, fireplace or stove.
